Wolfcraft 3407 000 Instruções de Operação descarregar pdf (Página 33)

Nivisys, LLC Rev. 14 Aug 2014

2-13

2.12 Headmount Installation and Adjustment:

CAUTION

DO NOT PUT ON THE HEADMOUNT WHILE

THE MONOCULAR IS ATTACHED.

1. Prior to donning the headmount, loosen the four ends of the

chinstrap two inches from the sliding bar buckles.

2. Snap the front and rear snaps in place.

NOTE

IF THE HEADMOUNT IS TOO LOOSE,

REPLACE THE SMALL BROWPAD WITH

EITHER THE MEDIUM OR LARGE

BROWPAD SUPPLIED WITH THE

HEADMOUNT.

3. Grasp the neck pad and pull the harness over your head and

the neck pad down to the back of your neck.

4. Holding the chin cup in position on chin, adjust both sides

of the chinstrap until you feel light pressure against your

chin. (DO NOT TIGHTEN.)

5. Maintain the position of the chin cup and remove any slack

from the chinstrap. (DO NOT TIGHTEN.)

6. Ensure that the cross-strap is not twisted and remove slack

by adjusting the vertical adjustment at the neck pad.

7. Adjust chinstrap and vertical adjustment until the chin cup

and headband are in a comfortable but firm position.

8. Install the head/helmet mount interface.

NOTE

AFTER INSTALLING THE MONOCULAR,

MINOR STRAP ADJUSTMENTS MAY BE

NECESSARY TO ACHIEVE COMFORT.

1 2 ... 28 29 30 31 32 33 34 35 36 37 38 ... 73 74

Sem comentários

Wolfcraft 3407 000 Instruções de Operação Página 33